(Removed 'not in space' category.)
|Line 46:||Line 46:|
Last edited: [[User:Mysterious Paul|Mysterious Paul]] [[User:Mysterious Paul|Mysterious Paul]]
Last edited: [[User:Mysterious Paul|Mysterious Paul]] [[User:Mysterious Paul|Mysterious Paul]] :, ()
Revision as of 14:50, 28 January 2013
|Remember to always; clean up and return the equipment to a fully functional, safe state before you leave. This includes returning any safety mechanisms to fully working order.|
DIY Lil' CNC
A three-axis CNC-controlled Dremel tool
- Ownership: Paul Kerchen (100%)
- Location: In the center of the shop near the Torquecut.
- What it looks like:
- Make/Model: Built from DIYLILCNC plan version 1.0.3; the Dremel tool is a 300 Series.
- Part Number: not specified
You must contact the owner about getting an account on the linux box that runs the machine.
- Generate G code
- Load G code into AXIS (or one of the other front-ends).
- Secure workpiece
There is no routine maintenance required. When you're done with it, be sure to power down the controller box AND the linux box (it doesn't automatically power down on shutdown).
Due to an oversight while building it (forgot to put a flat on the bar that the set screw screws into), the y-axis pulley may become loose over time. If this happens, you'll need to remove the access panel on the y-axis uprights and tighten the set screw.
Things that Need to be Done
- Build a better workpiece holder
- Tie into shop dust collector
- Can I mill printed circuit boards on this thing? Hasn't been done yet, but should be possible.
- Can I drill printed circuit boards on this thing? Yes! Basically, you just need to translate your drill file to the lingua franca of the mill, G code.
- How do I secure my work piece when milling? The base now has a removable piece of MDF with several 1/4-20 blind nut inserts embedded in it. Using 1/4-20 bolts and fender washers, you can secure your work piece fairly well.
- How fast is the spindle on the Dremel tool? It's variable from 5,000 to 35,000 RPM.