DIYLILCNC
From i3Detroit
 | Remember to always; clean up and return the equipment to a fully functional, safe state before you leave. This includes returning any safety mechanisms to fully working order. |
DIY Lil' CNC
A three-axis CNC-controlled Dremel tool
Basic Info
- Ownership: Paul Kerchen (100%)
- Location: In the center of the shop near the Torquecut.
- What it looks like:
Manufacturer Information
- Make/Model: Built from DIYLILCNC plan version 1.0.3; the Dremel tool is a 300 Series.
- Part Number: not specified
Documentation
not specified
Rules
You must contact the owner about getting an account on the linux box that runs the machine.
Instructions
- Generate G code
- Load G code into AXIS (or one of the other front-ends).
- Secure workpiece
- Cut
- Profit!
Other References
Maintenance
There is no routine maintenance required. When you're done with it, be sure to power down the controller box AND the linux box (it doesn't automatically power down on shutdown).
Due to an oversight while building it (forgot to put a flat on the bar that the set screw screws into), the y-axis pulley may become loose over time. If this happens, you'll need to remove the access panel on the y-axis uprights and tighten the set screw.
Things that Need to be Done
- Build a better workpiece holder
- Tie into shop dust collector
FAQs
- Can I mill printed circuit boards on this thing? Hasn't been done yet, but should be possible.
- Can I drill printed circuit boards on this thing? Yes! Basically, you just need to translate your drill file to the lingua franca of the mill, G code.
- How do I secure my work piece when milling? Currently, you have to simply tape it down with masking/painter's tape. Eventually, a better system will be devised. If you have ideas about what such a better system might look like, please contact Paul Kerchen!
- How fast is the spindle on the Dremel tool? It's variable from 5,000 to 35,000 RPM.
Last edited: Mysterious Paul Mysterious Paul 00:38, 3 October 2011 (UTC)
