Revision as of 21:48, 12 January 2012

So, it's been a long day of hacking and you're the last one in the space. It's finally time to go home. But wait! Aren't you forgetting something?

Clean

1. Put your project away. Don't leave it on a workbench. Label it so others know it's yours.
2. Put tools back in the places from which you got them.
3. Sweep sawdust, wires, etc. from the floor.
4. If you did something the group should know about, make a post!

West shop

1. West shop fans (switch near men's bathroom)
2. West / rear shop lights (breakers near water heater)

Rear shop

1. Windows closed and locked
2. Air compressor electrically off
3. Air compressor valve closed
4. Machine-shop lights off
5. Machine-shop radio off
6. Thermostats (on wall by CNC) set back to Run (or 45 deg)

Commons area

1. Double-check tables are clear, retract cord-reel
2. Stereo off (amplifiers in rack)
3. Commons-area lights off (switches behind rack)

Welding area

1. Argon tank valve off, righty tighty
2. CO2 tank valve off, as above

Small rooms

1. Thermostat (wall by chem lab) set back to Run (or 50 deg)
2. Coffee pot (corner of kitchen) off, grounds basket empty, urn clean
3. Front (glass) door closed and locked, just give it a yank
4. Stinky garbage out before it gets stinkier

Door area

1. Roll-up garage door latch fully engaged
2. Fans off
3. Twitterbot switch down, make sure light goes off
4. Door-area light off
5. Goodnight!

THANK YOU TREMENDOUSLY for your thoroughness!