Jointer
Contents |
Jointer
The status of the jointer in the Wood Shop is in flux. The current jointer, which was made by Delta, has limited table adjustments by design. This would be fine if the infeed and outfeed tables were aligned, but they are not, and no practical way has been found to align them. As a result, a board fed through this jointer gets a curved edge rather than the straight edge needed for quality wood working. Plans are being made to replace the current jointer with a used model equipped with tables that can be aligned.
Ownership
Nick Britsky
Documentation
(Add a link to the documentation online, or a PDF file using a File link)
Certification
(Undefined - or "None Required" or include information about what certification is required before operating this machine)
What It Looks Like
The jointer is currently disassembled:
Operation Instructions
Include basic operations for the machine.
Set the cutting depth
The depth adjustment ...
Turn it On
The power switch is located ...
Turn it Off
The power switch is located ...
FAQs
- What is a jointer? Wikipedia has an excellent article on the Jointer.
