Jointer
 | Remember to always; clean up and return the equipment to a fully functional, safe state before you leave. This includes returning any safety mechanisms to fully working order. |
Jointer
The status of the jointer in the Wood Shop is in flux. The current jointer, which was made by Delta, has limited table adjustments by design. This would be fine if the infeed and outfeed tables were aligned, but they are not, and no practical way has been found to align them. As a result, a board fed through this jointer gets a curved edge rather than the straight edge needed for quality wood working. Plans are being made to replace the current jointer with a used model equipped with tables that can be aligned.
Basic Info
- Ownership: Nick Britsky
- Location: Tell people where to find it, and where to put it away.
- What it looks like:
The jointer is currently disassembled:
Manufacturer Information
- Make/Model: Acme CNC Yak Shaver - Model 5000 deluxe
- Part Number:
Documentation
not specified
Rules
Put the rules that govern the use of this tool here.
- You can use any wiki formatting that you wish:
- Like a bulleted list
Instructions
Set the cutting depth
The depth adjustment ...
Turn it On
The power switch is located ...
Turn it Off
The power switch is located ...
Other References
not specified
Maintenance
Does this thing need it's oil changed every 30 cycles? People need to know!
Things that Need to be Done
What problems does this thing have, or are there improvements that would make it better.
FAQs
- What is a jointer? Wikipedia has an excellent article on the Jointer.
